Blizzard Lighting Q12A The Puck (Rev B) - Manual (Page 10)

Page 10
The Puck Q12A / Q12W Manual Rev. B Copyright (c) 2011-12 Blizzard Lighting, LLC
4. OPERATING ADJUSTMENTS
NOTE: After making any adjustment, hold the
3 seconds, otherwise the fi xture will return to the correct mode after approxi-
mately 10 seconds.
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fi xture is DMX, which appears as
Addr
on the LED
Readout. Use the button then the and buttons to
choose a channel between
1
and
512
. Press again to confi rm.
2.) To change between 4 and 7 channel DMX mode, select
ChNd,
then press
. Select either
7Ch
or
4Ch
, then press again to con-
fi rm.
Master/Slave Mode (Auto/Sound Active/Color Preset/Custom):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the fi rst unit. Finally, chain the units together using DMX cable.
Master
SLNd
then
NASt
to confi rm.
3.) Select slave function by using the / keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLNd
then
SLAu
to confi rm.
NOTE: Fixtures in slave mode will display “
STBY
“ (Standby). This is NORMAL.
Return the fi xture to master mode to use it as a standalone fi xture.
4.) On the master fi xture, use the / keys to reach SHND, which
allows you to select the Master/Slave mode.
Sound active
SoUn
then to confi rm.
Auto mode
CoLo
then
Auto,
then to confi rm.
Color preset
CoLo
then
CoL 1 - CoL 15,
.
Fade Mode
FAdE
then
SP 1 - SP 8,
.
NOTE: Speed 1 = Fastest (Approx. 1.5 sec. per color), Speed 8 = Slowest (Approx.
2 min. per color).