Blizzard Lighting RGBAW ROCKLITE (Rev B) - Manual (Page 14)

Page 14
ROCKLITE RGBAW Manual Rev. B Copyright (c) 2010 Blizzard Lighting, LLC
DMX Values In-Depth (4/5-Channel Mode)
Ch. Value What It Does (5 Ch.) What It Does (4 Ch.)
1 000 <--> 255 Red Intensity Red Intensity
2 000 <--> 255 Green Intensity Amber Intensity
3 000 <--> 255 Blue Intensity White Intensity
4 000 <--> 255 Amber Intensity Dimmer (0-100%)
5 000 <--> 255 White Intensity ---
Troubleshooting
Symptom Solution
Fixture Auto-
Shut Off
Check the fan in the fixture. If it is stopped or moving
slower than normal, the unit may have shut itself off due to
high heat. This is to protect the fixture from overheating.
Clear the fan of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/grime. Also
ensure that the 220V/110V switch is in the correct position,
if applicable.
No Light Output Check to ensure fixture is operating under correct mode, IE
sound active/auto/DMX/Etc., if applicable. Contact service
for more information.
Chase Speed
Too Fast/Slow
Check to ensure proper setup of speed adjustment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify that moving
parts are not restricted and that unit’s ventilation is not
obstructed
Slow Movement Verify that 220V/110V switch is in the correct position, if
applicable. Also check that speed channels are set appropri-
ately.
No Response to
Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding Er-
raticly
Make sure all connectors are seated properly and securely.
Use Only DMX Cables.
Install a Terminator.
Check all cables for defects.
Reset fixture(s).
Intermittant
Lamp
Check lamp for properly installation.
Relamp, lamp may have reached end of life.
Remote Doesn’t
Work
Verify remote control cable is installed properly and securely.
Verify remote is correct type (CA-9 or other as applicable.)
Fixture Moving
On Its Own
Verify proper mode of operation. Is the fixture in “Auto”
mode?
If your problem isn’t listed, or if problems persist,
please contact support: [email protected].