Blizzard Lighting LED ProPar (Rev B) - Manual (Page 6)

Page 11
ProPar LED Manual Rev. B Copyright (c) 2010 Blizzard Lighting, LLC
Control Panel Menu Structure
Page 12
ProPar LED Manual Rev. B Copyright (c) 2010 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller. If you are unfamiliar with
DMX, please read the DMX Primer on page #15.
1.) The default mode for the fi xture is DMX, which appears as
A001
on the LED
Readout.
Master/Slave Mode (Auto or Sound Active):
Allows you to link up to 32 units together without a controller.
1.) Use standard DMX cables to daisy chain your units together via the DMX con-
nector on the rear of the units. It may be necessary to use a terminator at the
last fi xture. For more information about terminators, see page 8.
2.) Choose a unit to function as the Master. Select MAST. The master unit must
be the fi rst unit. Finally, chain the units together using DMX cable.
Master
NASt
then
YES
to confi rm.
3.) Select slave function by using the / keys to reach SLAV in
the Master/Auto menu on the slave units, and they will react in the same as the
Master.
Slave
SLA
then
YES
to confi rm.
Select either
Auto
or
SUNd
(Sound Active mode)
then
YES
to confi rm.
Stand-Alone Mode (Progam Mode):
Allows a single or Master/Slaved units to run to one of four factory installed programs at
user selectable speeds.
1.) To set the fi xture in Program mode, select
PrOG
.
To confi rm, press the button while the display reads
YES
.
2.) Now, select programs C1-C4 by using the and buttons,
then press the button to confi rm while the display reads
YES
.
3.) Finally, select the program speed by using the and buttons,
to adjust the speed from
P255
(slowest) to
P001
(fastest).
Manual Mode (Color Preset Mode):
Allows a single unit to display any of 16,700,000 colors without a DMX controller.
1.) To set the fi xture in manual mode, select
NaN
.
To confi rm, press the button while the display reads
YES
.
2.) Now, choose the color you would like to adjust by using the and
buttons to select
rEd
,
GrE
or
bLU
.
To confi rm, press the button while the display reads
YES
.
3.) Finally, adjust the intensity of each color by using the and
buttons while the display reads
L001
(least intesity) to
L255
(most).
Confi rm by pressing the button while the display reads
YES
.