Page 12 – Blizzard Lighting PixelStorm (Rev A) User Manual

Page 12

Page 12

PixelStorm User Manual Rev. A

DMX Mode

Allows the unit to be controlled by any universal DMX controller.

1.) Depending on what channel mode you would like to use, you first need to

choose one of the four DMX channel mode configurations:

Nod1

- To choose 4 channel DMX mode

Nod2

- To choose 7 channel DMX mode

Nod3

- To choose 16 channel DMX mode

Nod4

- To choose 34 channel DMX mode

Use the buttons to scroll to

Nod -

and push the

button. Then use the buttons to scroll to your choice of 4/7/16

or 31 channel mode, then hit the button.

2.) Then depending on which DMX channel mode you entered, you can set the

DMX starting address. You’ll notice that the first letter in this setting changes

per mode:

C001 - C512

- To set the starting address of Mode 1 (4ch)

d001 - d512

- To set the starting address of Mode 2 (7ch)

E001 - E512

- To set the starting address of Mode 3 (16ch)

F001 - F512

- To set the starting address of Mode 4 (34ch)

Use the buttons to scroll to

---,

---, or

--- and push

the button. Then use the buttons to scroll to your

choice (1-512), then hit the button.

Master/Slave Modes:

Allows a single or Master/Slaved units to run factory installed programs at user

selectable speeds.

1. The first fixture in the DMX chain will serve as the master unit. To set other

fixtures in line to slave mode, make sure these fixtures have a starting DMX

address that is set to match that of the master unit.

For example, if your master fixture has the DMX starting address of C001, all

other fixtures linked in the DMX chain must match that DMX starting address of

C001

. These fixtures will now function exactly as the master does.