Page 12, Additional user adjustments – Blizzard Lighting ICE 30 30W LED Moving Head Spot(Rev A) User Manual

Page 12

Page 12

ICE 30 Manual Rev. A

Additional User Adjustments

To restore all settings to their factory defaults:

1) Use the “Load Data” function in the menu (see page 11).

Operation

Master/Slave Mode (Master Sound, Master Auto):

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on

the rear of the units. For longer cable runs we suggest a terminator at the last fi xture.

2) Choose a unit to function as the Master. Turn dipswitches to the Master position on the

unit. The unit must be the fi rst unit in line. Then simply chain the units together using DMX

cable.

Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for

setting the options in the menu and navigating the Control Board.

3) Adjust the “Operation” to “Slave” on the slave units, and they will react the same as the

Master unit.

Note: if you would like to have the fi xtures inverted, this can be set in the Control board.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfa-

miliar with DMX, please read the DMX Primer section.

1) Set the menu to “Address.”
2) Set your DMX starting address, and hit to confi rm.

DMX Channel Values

The ICE 30™ has 2 DMX channel profi les (operation modes). These can be accessed in the
Control Board.