Page 13 – Blizzard Lighting ICE 30 30W LED Moving Head Spot(Rev C) User Manual

Page 13

Page 13

ICE 30 Manual Rev. C

Additional User Adjustments

To restore all settings to their factory defaults:

1) Use the “Load Data” function in the menu (see page 12).

Operation

Master/Slave Mode (Master Sound, Master Auto):

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of

the units. For longer cable runs we suggest a terminator at the last fixture.

2) Choose a unit to function as the Master. Turn dipswitches to the Master position on the unit. The

unit must be the first unit in line. Then simply chain the units together using DMX cable.

Note: The master unit must be in one of the Auto or Sound modes. See the Menu Map for setting

the options in the menu and navigating the Control Board.

3) Adjust the “Operation” to “Slave” on the slave units, and they will react the same as the Master

unit.

Note: if you would like to have the fixtures inverted, this can be set in the Control board.

DMX Mode

This mode allows the unit to be controlled by any universal DMX controller. If you are unfamiliar

with DMX, please read the DMX Primer section.

1) Set the menu to “Address.”
2) Set your DMX starting address, and hit to confirm.

DMX Channel Values

The ICE 30™ has 2 DMX channel profiles (operation modes). These can be accessed in the Control

Board.

Gobo Replacement

1) Remove the gobo cover by removing the two screws on the top of the fixture head.

2) Remove the slot-n-lock gobo from the gobo wheel by lifting up slightly and sliding it out.

3) Using a small tool, pry the tension ring from the gobo holder.

4) Remove the old gobo.

5) Insert the new gobo, and replace in the reverse steps of removal.