Blizzard Lighting 500 HushPar Infiniwhite - Manual (Page 15)

Page 15
HushPar Infiniwhite Manual Rev. A © 2014 Blizzard Lighting, LLC
DMX Values In-Depth (3-Channel ACW Mode)
ch. Value What it Does (3 ch.)
1 000 <--> 255 Amber Intensity (0% <--> 100%)
2 000 <--> 255 Warm White Intensity (0% <--> 100%)
3 000 <--> 255 Cool White Intensity (0% <--> 100%)
troubleshooting
Symptom Solution
Fixture Auto-Shut
Off
Check the fan in the fixture. If it is stopped or
moving slower than normal, the unit may have
shut itself off due to high heat. This is to pro-
tect the fixture from overheating. Clear the fan
of obstructions, or return the unit for service.
Beam is Dim Check optical system and clean excess dust/
grime. Also ensure that the 220V/110V switch
is in the correct position, if applicable.
No Light Output Check to ensure fixture is operating under cor-
rect mode, IE sound active/auto/DMX/Etc., if
applicable.
Chase Speed Too
Fast/Slow
Check to ensure proper setup of speed adjust-
ment.
No Power Check fuse, AC cord and circuit for malfunction.
Blown Fuse Check AC cord and circuit for damage, verify
that moving parts are not restricted and that
unit’s ventilation is not obstructed
Slow Movement Verify that 220V/110V switch is in the correct
position, if applicable. Also check that speed
channels are set appropriately.
No Response to
Audio
Verify that the fixture is in “Sound Active” mode.
Adjust Audio Sensitivity, If Applicable.
Fixture Not
Responding /
Responding
Erraticly
Make sure all connectors are seated properly
and securely.
Use Only DMX Cables and/or check cables for
defects
Install a Terminator.
Reset fixture(s).
Fixture Moving On
Its Own
Verify proper mode of operation. Is the fixture
in “Auto” mode?
if your problem persists or isn’t listed contact [email protected].