Blizzard Lighting HotStik - Manual (Page 14)

Page 14
HotStik™ User Manual - Rev. A (c) 2013 Blizzard Lighting, LLC
DMX Mode
Allows the unit to be controlled by any universal DMX controller.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the
d.001
(5ch mode), or
A.001
(9ch
mode). To change the DMX starting address within either of these, use
the buttons to scroll from
001 to 512 . Press
to confirm your choice.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user
selectable speeds.
1.) To set the fixture in Color Fade mode, select CF.-- . Then use the
buttons to scroll from CF.01 to CF.99 (Slow <--> Fast).
2.) To set the fixture in Color Change mode, select CC.-- . Then use the
buttons to scroll from CC.01 to CC.99 (Slow <--> Fast).
3.) To set the fixture to display any of its built-in Color Macros, select
CS.-
- . Then use the buttons to scroll from CS.01 to
CS.99 (Slow <--> Fast).
4.) To set the fixture as a slave unit, simply daisy chain 2 or more units
via DMX. The 1st fixture in the chain will serve as the master, and the
following fixtures will act as the master unit does.
Auto/Demo Mode:
1.) To set the fixture in Auto mode, select DENO .
Sound Active Mode:
1.) Sound active mode is available via 9ch DMX Mode between the
values of 240 <--> 255.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture.
1.) Use the r.--- (Red Level), 9.--- (Green
Level), b.--- (Blue Level), Y.--- (Amber), or U.--- (White Level), then
hit .
2.) Using the buttons, select the maximum level for
each color between
000x255 (000=off), then hit to confirm.