beautypg.com

Connections, Beolink passive receiver – Bang & Olufsen BeoLink Passive - Setting-up Guide User Manual

Page 7

background image

7

BeoLink Passive receiver
Use the cable supplied (or the
optional special low capacity
cable mentioned on page 4)
and connect the BeoLink
Passive receiver as explained
here:

1 Cut the cable to the required

length (from the BeoLink
Passive amplifier box to the
receiver) and strip it as

shown.

2 Insert the cable end through

the cable clamp (F) and con-
nect the leads to the termi-
nals inside the receiver in the
order indicated. Then tighten
the clamp (F).

3 Attach the rear cover and fix

the BeoLink Passive receiver
to the wall as explained on
page 5.

4 Plug the cable into the socket

marked IR on the BeoLink
Passive amplifier box.

All cables should be handled

with great care. When running
the cables, avoid bending them
too sharply and be careful not
to twist them. Avoid subjecting
the cables to pressure or impact.

C O N N E C T I O N S

35 mm – 11/2"

5 mm – 1/4"

F

1
2
3
4
5

Strip the receiver cable end.

Twist the cores in each lead

and bend them back.

Connect the leads in the
receiver cable to the terminals

inside the receiver in this order:
1 = Yellow
2 = Grey
3 = Green
4 = White
5 = Brown