Balboa Water Group Dolphin II Spa Only - Manual (Page 8)

8
TROUBLESHOOTING
PROBLEM: LED does not blink when you press a key.
SOLUTION: Replace the batteries with two (2) new AA
alkaline batteries (see page 3).
PROBLEM: Dolphin does not control spa. LED blinks
when you press a key, but receiver does
not respond.
SOLUTION: Make sure you are within 15 feet of the spa
and aiming the Dolphin directly at the
receiver.
If spa has RF receiver: 1) Try it at different
distances. You may be too close or too far
away. 2) Make sure the correct address is
set on the spa for the set up code you
entered on the Dolphin. (See page 6.) Set
the spa address back to 0 (no address). If
your spa has addressing capability, enter
set up code BBBB on the Dolphin. If that
works, set a new address on the spa, and
enter the corresponding set up code on the
Dolphin.
If it stops working again, the necessary
equipment for address is probably not
installed in the your spa. In that case, set it
back to 0/BBBB and leave it there.
PROBLEM: Dolphin and spa are set to an address but
still experiencing interference from
neighbor’s spa.
SOLUTION: You and your neighbor may have chosen
the same address. Choose a different
address and corresponding set up code.
PROBLEM: My spa was just serviced. Everything works
now, except for my remote.
SOLUTION: Reprogram the spa address last used.
Repeat the Spa Addressing procedure if you
don’t remember the address. (See page 6.)
SPECIFICATIONS
Remote Control Power
2 AA Batteries
Remote Control RF Range to the Spa
up to 100 Feet (30.48 m)*
Remote Control Dimensions (H x W x D)
9-2⁄16 x 2-10⁄16 x 1-3⁄16 in.
232 x 65 x 31 mm.
Remote Control Weight (without Batteries)
8 oz (220 g)
*Distance may vary
NOTE: Specifications are typical. Individual units
may vary. Specifications are subject to change and
improvement without notice.