AJA D10C2 - Manual (Page 5)

1
5 AJA D10C2 10-bit Serial Digital to Composite/Component Converter User Manual — User Controls
User Controls
The user interface for the D10C2 is a 4-switch DIP
accessible through a cut-out in the bottom of the
unit. Use the DIP switches to configure outputs,
pedestal, and blanking.
Switch 1 selects the type of output. Switches 2
through 4 select the output video format, pedestal
and blanking. The exact function of each DIP switch
and what it controls is described on the following
pages.
Switch 1 Selects Composite or Component Video Output
:
Switch 2 Select RGB Or YPbPr Output (3 BNCs)
:
Switch 3 Set Pedestal and Levels for YPbPr
:
Note: This switch has no effect on 625 input
ON OFF
Selects component video
output Selects composite video out
ON OFF
Selects YPbPr output on the 3
BNCs when SW1 is set to
COMPNT (ON) Selects RGB output on the 3 BNCs
when SW1 is set to COMPNT (ON)
ON OFF
7.5 IRE pedestal for NTSC (also
selects BETA 525 levels for
YPbPr) No pedestal (also selects SMPTE
levels for YPbPr)
DIP Switches
OFF ON