AJA FiDO User Manual
Page 6
6
2.
Apply +5 to 20VDC power to the converter (AJA power supply model DWP or
DWP-U recommended).
No configuration or settings are required. Once powered, the FiDO converters will
begin converting applied fiber/SDI signals.
Warning!
Active fiber-optic cables emit radiation invisible to the human eye. Do
not look directly at the end of an active fiber-optic cable or the fiber
connector on a FiDO-TR, FiDO-T, FiDO-2T, FiDO-T-SC, or FiDO-T-ST;
these models are Class 1 Laser Products.
Shown above: FiDO to Duplex LC connection. Insert cable connector until it latches.
FiDO-TR, FiDO-2T, and FiDO-2R all require either a duplex LC cable or two simplex LC
cables. FiDO-T and FiDO-R only require a single simplex LC cable connected to the
optical port on the converter pointed to by the arrow (Optical In on FiDO-R or Optical
Out on FiDO-T).
FiDO-T-SC and FiDO-R-SC only require a single simplex SC cable connected to the
optical port on the converter pointed to by the arrow (Optical In on FiDO-R-SC or
Optical Out on FiDO-T-SC).
FiDO-T-ST and FiDO-R-ST only require a single simplex ST cable connected to the
optical port on the converter pointed to by the arrow (Optical In on FiDO-R-ST or
Optical Out on FiDO-T-ST).
All FiDO models require “single mode, 1310nm compatible” fiber optic cable.
CLASS 1
LASER
PRODUCT
FiDO-T-SC and
FiDO-R-SC
Optical Connector
FiDO-T-ST and
FiDO-R-ST
Optical Connector