Billion Electric Company BIPAC-2AB 2.0 - Manual (Page 8)

Chapter 2
Using BIPAC-2AB 2.0
Before Connecting
Make sure that you have all you need to connect the BIPAC-2AB 2.0 ISDN a/b
adaptor. You should have the following:
1. At least one analog telephone (or other analog device)
2. A power outlet that supplies 220 ~ 240 volts AC
3. An ISDN basic rate S
0
interface released by PTT (Post, Telephone
and Telegraph administration)
Connecting the BIPAC-2AB 2.0
Please refer to the following instructions and figures for installation procedures:
1. Connect one or two analog telephones (or other analog devices) to the
RJ-11 jacks labeled “a/b 1” or “a/b 2” on the back of the BIPAC-2AB
2.0. Refer to Figure 2.
2. Connect your ISDN line to the RJ-45 jack labeled “ISDN S
0
” on the
back of the BIPAC-2AB 2.0. Refer to Figure 2.
3. Plug the power adaptor into the power outlet. The POWER LED will
illuminate on the front panel.