Briggs & Stratton 2700PSI - Manual (Page 5)

Snapper 2700 PSI Pressure Washer
5
IMPORTANT: Read entire owner’s manual before you
attempt to assemble or operate your new pressure washer.
REMOVE PRESSURE
WASHER FROM
CARTON
• Remove all accessories and parts bag included with
pressure washer.
• Slice two corners at the end of carton from top to
bottom so the panel can be folded down flat, then
remove all packing material.
• Roll pressure washer out of carton.
Carton Contents
Items in the carton include:
• Main unit
• High pressure hose
• Handle
• Pump oil dipstick (hanging on pump)
• Bottle of engine oil
• Safety goggles
• Spray gun with quick connect fitting
• Nozzle extension with quick connect fitting
• Accessory bag (includes the following):
• Owner’s registration card
• Nozzle cleaning kit
• Bag containing 5 multi–colored quick connect nozzles
• O–Ring maintenance kit
• Owner’s manual
• Engine manual
• Handle hardware, including one carriage bolt, one
“L” bolt and 2 plastic knobs
If any of the above parts are missing or damaged, contact
the local Snapper service center.
PREPARING PRESSURE
WASHER FOR USE
If you have any problems with the assembly of your
pressure washer or if parts are missing or damaged,
contact the local Snapper service center.
To prepare your pressure washer for operation, you
will need to perform these tasks:
• Fill out and send in the registration card.
• Attach the handle to the main unit.
• Add oil to the engine.
• Add fuel to the fuel tank.
• Connect the high pressure hose to the spray gun and the
pump.
• Connect the water supply to the pump.
• Connect nozzle extension to spray gun.
• Select and install desired nozzle.
Attach Handle to the Pressure
Washer
• Place the handle onto the handle supports already
connected to the main unit. Make sure the holes in the
handle align with the holes on the handle supports.
(Figure 1)
NOTE: It may be necessary to move the handle supports
from side to side in order to align the handle so it will slide
over the handle supports.
• Insert the carriage bolt through the hole on the left side
of the handle (viewing from rear of unit) and attach the
plastic knob (Figure 2). Tighten the knob by hand.
Make sure the
holes on the
handle are
aligned with the
holes on the
handle supports Handle
Handle
Supports
Figure 1 — Attach the Handle to the Base