Blaupunkt CARACAS RCR 87 - Manual (Page 13)

25
ENGLISH
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
SVENSKA
ESPAÑOL
PORTUGUÊS
Reversing the tape (autoreverse)
To change the tape direction during casset-
te playback:
•
Press FR and FF briefly.
At the end of a tape side the mechanism
changes directions automatically to play the
other side (autoreverse).
The display shows “TR 1” for track (side) 1
or “TR 2” for track 2.
Note:
If there is too much tension on the tape du-
ring playback, the set may switch over by
itself before having reached the end of the
tape side. In this case check the condition
of the cassette tape. Sometimes it helps to
rewind it completely.
Care notes
To avoid possible problems, we recommend
you to use C-60/C-90 type cassette tapes
only. Store your tapes in a cool place away
from dirt, dust and temperatures exceeding
50
° Celsius. Allow very cold tapes to warm
up before playing them in order to avoid
uneven tape transport. After approximately
100 hours of use, dust particles collected
on the playback head or roller may lead to
tape run problems and sound distortions.
Use a head cleaning tape to remove nor-
mal dirt build-up. For tougher cases, use a
cotton swab (Q-Tip) dipped in alcohol. Do
not attempt to clean by inserting a hard ob-
ject into the player!
Appendix
Specifications
Amplifier
Output power:
Caracas RCR 27
2 x 5.5 W RMS power
acc. to DIN 45 324 at
14.4 V
2 x 10 W max. power
Rio RCR 87
4 x 19 W RMS power
acc. to DIN 45324 at
14.4 V
4 x 20 W max. power
Tuner
Wavebands:
FM:
87.5 - 108 MHz
MW: 531 - 1.602 kHz
LW: 153 - 279 kHz
FM sensitivity: 1.0 µ V at 26 dB
signal-to-noise ratio
FM frequency response:
35 - 15.000 Hz
Tape player
Frequency response:
35 - 15.000 Hz
Subject to modifications!