Britax Y2K 03.A - Manual (Page 7)

Installing the Bumper Bar:
Insert the bumper bar support rods into the slots on the
armrests until locked in place (C-1).
Installing the Seat Pad:
Unfasten all harness clips (D-1). Place seat pad on seat unit,
aligned so that the attachment clips are near the headrest
area. Pull harness through the appropriate slots in the seat
pad, then refasten without twisting the harness straps.
Attach seat pad to the stroller by fastening the clips on the
pad to the stroller shell.
Installing the Hood:
Insert tabs into slots on each side of stroller chassis. Verify
that hood is secure.
C
Initial Assembly
5
D
P2296_R02lowres.qxd 2/6/2004 1:43 PM Page 7