WORX WU645.1 210W Palm Sander 240V - Manual (Page 8)

8
1
2
3
Operating instructions
note: Before using the tool, read the instruction book carefully.
intended uSe
The machine is intended for dry sanding of wood, plastic, filler and
coated surfaces.
on/off SWitcH
To start your sander, depress the protective cover over the
switch at the position marked“I” . To stop your sander, depress
the protective cover at the position marked “0”.
Hand gRiP aRea
You can operate your sander with one hand (See Fig. A).
cHanging tHe Sanding PaPeR
To remove the sanding paper, lift up the Clamp Lever (4) and
move away from the Lever Lock (5) (see B). The Sanding Paper
Clamp (3) is now loose. Repeat with the other clamp on the
opposite side of your sander.
To fit new sanding paper, insert approximately 5mm of one end
of the sanding paper under the Sanding Paper Clamp (3) until
the paper contacts the housing wall (see B). Lift up the Clamp
Lever (4) and move it to the lever lock position.
Press the sanding paper around the base-plate shape as tight as
possible and fix the end under the other Sanding Paper Clamp
(3). Check the Sanding Paper is square to the base-plate and
remove and refit again if not correct.
Always, ensure the Sanding Paper is tight over the base-plate
A
B