Installation – Wood’s Powr-Grip LB12AEO User Manual
Page 5

Rev 0.1/4-10
3
LB12AEO: #35208AFT
INSTALLATION
T
O
A
DAPT THE
O
RIGINAL
L
IFT
B
AR
1) Follow the MRTA6 lifter's instruction manual to verify that the
lifter is in good working order.
2) Remove the molded rubber end plug from the end of the lift
bar on the vacuum lifter.
3) Using an appropriate drill and bit, drill a 17/32" hole through
both ears and the tube of the lift bar at the location shown in
the figure at right. Then deburr as necessary.
T
O
I
NSTALL THE
A
DJUSTABLE
E
XTENSION
1) Remove the Adjustable Lift Bar Extension (2) from its
protective packaging. Then remove the molded rubber
end plug from the end of the lift bar (1) on the vacuum
lifter.
Note: Check the end of the lift bar tube for any excess
welding material that could prevent the adjustable
extension from sliding into the lift bar. If so, use a
metal file or other appropriate tool to remove this
material.
2) Insert the adjustable extension into the lift bar as shown
and position the adjustable extension to align the holes
for the desired length (see OPERATING FEATURES).
WARNING: Do not reverse extension orientation.
Be sure to install the adjustable extension in the same
orientation as shown. The adjustable extension is not
intended to be reversed.
3) Insert the hex head bolt (5) with one flat washer (7)
through the lift bar and adjustable extension.
4) Install another flat washer (7), followed by the lock
washer (8) and the hex nut (6) on the threaded end of
the bolt protruding from the lift bar.
5) Using appropriate wrenches, tighten the bolt securely,
being careful not to crush the outer tube.
6) Position the lift shackle and pin (3) at the desired lift point location (see ensuing discussion)
and secure them with the hairpin (4).