beautypg.com

Wood’s Powr-Grip FLEX5HV11AIR User Manual

Page 14

background image

Rev 8.0/8-12

12

FLEX-HV11AIR: #35033

T

O

R

ELEASE THE

P

ADS FROM THE

L

OAD

WARNING: Load must be fully supported before releasing vacuum pads.

When the load is at rest and fully supported, move the lever on the vacuum control valve to the

"RELEASE" position: Pull upward on the lever's knob, move the lever all the way

back

(towards

operator) and then release it. This forces air into the vacuum pads, quickly breaking the vacuum
seal. After the pads have disengaged completely from the load, move the lifter away. Then

place the lifter in stand-by mode as directed in the following discussion.

About Stand-By Mode

The lifter's vacuum control valve features a neutral position that reduces the amount of time

required for the lifter to attach to a load and obtain full vacuum. To utilize this feature, pull

upward on the lever's knob, move the lever to the

center

position and then release it. Placing

the valve lever in the center position closes off the vacuum line that connects the vacuum pads
to the vacuum generating system, causing vacuum to build up in the line.

WARNING: Never move valve lever to center position while lifter is supporting

load.

Stand-by mode may only be used when the lifter is not supporting a load. The operator must

never move the valve lever to the center position while the lifter is supporting a load, because
this could result in a load release and possible injury to the operator.

A

FTER

U

SING THE

L

IFTER

Move the slide on the air supply valve to the “OFF” position.

CAUTION: Do not set the lifter against any surfaces which could soil or damage the

vacuum pads.

If the lifter is transported to another location, use the original shipping container and secure the

lifter so as to protect the vacuum pads and all other components from damage while in transit.

Storing the Lifter

Use the covers supplied to keep the vacuum pads clean.