Wood’s Powr-Grip CF6PSCH - Manual

Rev 1.0/3-09 APPENDIX • OPTION CF6PSCH #35175: 1
PARKING STANDS / CONTROL HANDLES
S
PECIFICATIONS
Model Number: CF6PSCH
Weight: 13 lbs [6 kg]
Note: Make sure to add the weight of all options to the Lifter Weight when you are
selecting appropriate hoisting equipment (see ASSEMBLY in main instructions).
Function: This option provides ergonomic control handles during lifter operation, or sturdy
parking stands when the lifter is not in use.
A
SSEMBLY
Assemble the vacuum lifter as directed in the ASSEMBLY section of
the main instructions. In addition, move the control handles at the
ends of the pad frame to the position desired for managing the
load, as follows: Use the pull ring to remove the cotterless hitch
pin from one handle pivot, and pivot the handle into the desired
position (either straight out or straight up from the pad frame).
When the holes for the cotterless hitch pin are aligned, push the
pin through the holes until the retaining ball emerges on the far
side of the pivot. Repeat this procedure for the second handle
.
O
PERATION
Operate the vacuum lifter as directed in the OPERATION section of the main instructions. In
addition, the control handles can be used as parking stands when an unloaded lifter is not
suspended from a crane: Secure the handles in position, pointing straight down from the pad
frame (see A
SSEMBLY
). Use the hoisting equipment to gently lower the lifter until the control
handles support its entire weight; then detach the hoisting equipment hook from the lift point.
In accordance with CE Standard EN 13155, the lifter is designed to rest on relatively
horizontal surfaces without tipping over. To store the lifter in this way, set the lifter down
on the control handles as described in the preceding section.
COTTERLESS HITCH PIN
1 PULL RING
2 RETAINING BALL