Waterpik WP-300 Quick Start - Manual

QUICK START GUIDE
Model
WP-300
1
Prepare the Reservoir:
Remove the reservoir from
base and fill with lukewarm
water.
Replace the reservoir onto the
base,
PRESSING DOWN FIRMLY
to ensure full seating.
Fill
Replace
When tip is properly
inserted there should be
no gap between handle
and colored tip ring.
2
Select and Insert Tip:
4
Prior to Very First Use of Unit, Prime
Unit:
Set pressure control dial on base to
high, point the handle and tip into sink.
Turn unit ON until water flows from the
tip. Turn unit OFF.
3
Prime Unit (First Time Use Only): Adjust Pressure Control:
For first time users, adjust pressure
control to
lowest position . Gradually
increase pressure to your liking.
Press tip
firmly into
handle.
Insert
High
I
1 2
3
O
1 2
3
I O
NO
Gap
This device is compatible with global voltages of 100 - 240VAC, 60/50Hz.
Low
I
1 2
3
O
1 2
3
I O
continued on back