WarmlyYours JSR12 ET-End-Kit End Seal Ki - Manual (Page 2)

1
WARNING:
ELECTRIC SHOCK HAZARD: Disconnect all power before installing or servicing heating cable and accessories. A qualifi ed
person must perform installation and service of heating cable and accessories. Heating cable must be effectively grounded in
accordance with the National Electrical Code. Failure to comply can result in personal injury or property damage.
Note:
1. All electrical wiring, including GFCI (Ground-Fault Circuit lnterrupters), must be done according to the National Electrical Code
or local codes by a qualifi ed person.
2. Article 426 of ANSI/NFPA 70 of the National Electrical Code (NEC) and Section 62 of CAN/CSA-C22.1, Canadian Electrical Code,
Part I (CEC) govern the installation of this heat system.
3. The ET-END-KIT End Seal Kit is suitable for use with ET-SR heating cables.
4. Keep ends of heating devices and kit components dry before and during installation.
ELECTRIC SHOCK HAZARD: To prevent short circuits, do not connect the bus wires together. Keep braid out of heat shrink cap.
46DV PIPE HEATING CABLE &
4FB1 DEICING AND SNOW
MELTING EQUIPMENT
ET-END-KIT Installation Instructions ET-END-KIT
Item Description Quantity
A Heat-Shrink Tube (5 in. long x ¾ in. dia.) 1
B Woven Braid Sleeving (4 in. long x ½ in. dia.) 1
C Heat-Shrink Cap (½ in. dia) 1
Caution:
ELECTRIC DE-ICING AND
SNOW MELTING EQUIPMENT
ON THE PREMISIS!
Fire and Electric Shock
ELECTRICALLY HEAT TRACED!
DISCONNECT BEFORE SERVICED!
WARNING
A
B
C