Waring Pro WPM30 - Manual (Page 7)

6
13. Keep POP switch off if the unit is not continuously in use.
14. Keep only the Light/Warmer switch on.
15. Remove plug from power supply if the unit is not
being used.
16. Repeat steps 9 to 14 for continuous popping.
CLEANING AND MAINTENANCE
It is strongly recommended to clean the kettle frequently to
avoid burning excess oil onto the bottom of the inner pot.
After using the popcorn machine, when the machine has
sufficiently cooled, use a wet cloth to clean the main unit,
main body and glass. It is strongly recommended to wash
and dry the tray after each use to avoid any bacteria buildup.
LIGHT/wARMER
The Light/Warmer bulb can be replaced with a 120V, 60W
maximum bulb only.
QUICK CLEANING PROCEDURE
Turn the POP control to Off. Pour 5 to 8 ounces of water
(NO detergent is necessary) into inner pot. Switch to On
to boil the water and let the stirrer turn in order to remove
excess oil stuck on the surface. Pour out the water into a
deep bowl and discard after about 1 to 2 minutes of boiling.
CAUTION: THE KETTLE IS HOT. SO USE AN OVEN MITT
TO HANDLE.
Or, remove the kettle and clean it with a Scotch-Brite
®
scouring pad. Do not immerse kettle or electrical plug
in water.