Waring Pro FS155 - Manual (Page 7)

6
use and Care
1. To use your Waring Pro ® Food Slicer, place on a sturdy, flat surface.
2. Check that the switch is turned off before plugging in
the appliance.
3. Adjust the slice control knob to desired slicing thickness
( 1 ⁄
32
" 5mm to ½" 15mm).
4. Position food to be cut on the stainless steel carriage and secure
with plastic safety guard.
5. Turn the Waring Pro ® Food Slicer on.
6. Position hand on food guide handles and smoothly slide carriage
backward and forward. neveR use youR fingeRs.
7. To ensure even slicing, do not press the food against the blade
too firmly.
8. At this point, check for desired thickness and adjust accordingly with
the slice control knob.
9. Continue to slide food carriage back and forth in an even and
steady motion. NOTE: Food carriage is removable for cleaning.
See #3 on page six.
10. After all your slicing is done, turn the slicer off and unplug.
The Waring Pro ® Food Slicer has been designed to operate for
short periods (maximum 10 minutes). Do not run for more than
10 minutes in constant use. Allow it to cool before using it again. If
the power cord is damaged, a service center recommended by the
manufacturer must repair it.
CleanIng & MaIntenanCe
Always unplug your Waring Pro ® Food Slicer and turn the slice control
knob back to zero before cleaning the appliance. do not put the
appliance in wateR. This could cause damage to electrical parts.
1. Clean and dry all parts immediately after use.
2. Fold out food carriage away from the base for easy cleaning of
crumb, seeds, etc.
3. To remove food carriage for cleaning, hold food carriage with two
hands and tilt frontward towards you. There is a button to release
the carriage marked "Press to release." Press, release, and wash with
warm soapy water. Dry thoroughly. To reassemble, align top part of
food carriage to bottom part of food carriage and click into place.
4. To remove blade, press in tab where indicated in center hub; twist
clockwise and carefully lift and remove blade.
5. With a soft sponge or cleaning cloth, clean both sides of blade with
mild soap and water. Rinse and dry blade thoroughly.
6. To replace blade, hold tab, aligning the blade with the drive gears so
it engages fully. Turn tab counterclockwise to tighten.
7. Any other servicing should be performed by an authorized
service representative.
DO NOT WASH ANY PART OF THIS SLICER IN A DISHWASHER.
TECHNICAL DATA
CARRIAGE SURFACE: Stainless Steel
Blade: Stainless Steel
POWER: 130W 120V/60Hz