Waring Pro HPB300 - Manual (Page 3)

4 5
3. Next, remove the top corrugated insert. Remove corrugated
ring and lift corrugated flap. Carefully lift blender base from
box and set aside.
4. Replace all corrugated inserts in the box and save for
repacking.
REPACKING INSTRUCTIONS
1. Place unit on a large, sturdy flat surface.
2. Carefully place blender base in bottom of box and cover
with corrugated flap.
3. Place corrugated ring over center of blade base and insert
long corrugated insert. Place blender container assembly
into long corrugated insert and cover with remaining
corrugated insert.
4. Close box for shipping.
GROUNDING INSTRUCTIONS
For your protection, Waring Pro ® Blenders are equipped with a
3-conductor cordset having a molded 3-prong grounding-type
plug, and should be used in combination with a properly connected
grounding-type outlet as shown in Figure A. If a grounding-type
outlet is not available, an adapter, as shown in Figure B, may be
obtained to enable a 2-slot wall outlet to be used with a 3-prong
plug. As shown in Figure C, the adapter must be grounded by
attaching its grounding lug under the screw of the outlet cover plate.
CAUTION: Before using an adapter, it must be determined that the
outlet cover plate screw is properly grounded. If in doubt, consult a
licensed electrician. Never use an adapter unless you are sure it is
properly grounded.
Note: Use of an adapter is not permitted in Canada.
This appliance is for 120 volts only and should not be used
with a converter.
IMPORTANT: HOT BLENDING INSTRUCTIONS
To minimize possibility of scalding when blending hot
ingredients, the following precautions and procedures must be
observed:
1. Limit amount of material processed to 1½ cups (12 oz.).
2. Completely remove the lid insert of the two piece
container lid before starting motor. (This will allow
venting of the rapidly heated and expanding air
present inside container when blender is running.)
3. Start blending on low speed.
OPERATING INSTRUCTIONS
1. When placing the container on the unit base, make sure that
the unit is turned off and is at a complete stop. Do not place
the container on the base or take it off while the unit is running.
If you do so, it may damage the drive shaft or blade assembly.
For best results, do not fill container above a 3-cup level.
2. Be sure the switch is in the OFF position and plug the blender
into a convenient outlet.
3. The Waring Pro ® MegaMix™ Blender is ideal for blending ice
drinks. A hint to help mix ice drinks: Keep the blades in the
container covered with liquid, turn the unit on, remove the lid
insert on top of the jar lid, and feed the ice cubes slowly into
the jar. NOTE: Never use containers other than Waring
Pro ® Blender containers with your Waring unit.
4. CAUTION: Do not use carbonated liquids in the blender jar,
or any blending container. Using carbonated liquids in the
blender jar or any blending container may result in injury.
5. Put ingredients into container and put on cover. Always add
liquid ingredients first, unless otherwise specified in recipe.
Always hold container with one hand while blending.