Vortex Optics RIDGEVIEW TRIPOD KIT User Manual
Page 2
©Vortex Optics USA 2009
M
J
Extending the leg length
Each tripod leg has four sections with padding on two of the upper leg
sections. To extend a leg, release the flip-lever
locks (M) and slide leg sections out to the desired
length. Press the flip-lever back down to lock a
section in place.
Warranty and Service
This product is warranted to be
free of defects in materials and
workmanship for three years
after purchase. Vortex Optics
will repair or replace such
product or part thereof that,
upon our inspection, is found
to be defective in materials or
workmanship.
If you need assistance using your
tripod, please contact:
Vortex Optics
2120 West Greenview Drive
Middleton, WI 53562
800-426-0048
Adjusting the variable leg angle spread
Adjust the tripod leg angles for ease of use in various
scenarios. Pull the leg
release button (J) and lift
the leg upward to one
of two different angle
positions. Repeat with
other legs as needed.
Adjusting the center column
Change the position of the center column (K) to gain additional height. Unlock the
center column by rotating the collar (G) in a counter-clockwise direction. Maneuver the
center column to the desired height and lock in place by rotating the collar in a clockwise
direction.
S
tabilize the tripod in windy conditions by hanging a counterweight
(not supplied) from the center column accessory hook (L).
Using the level
Use the leveling bubble (I) to gauge your alignment
and allow for optimum viewing and photography.
The tripod will be level when the bubble is within
the black circle.
Legs can be adjusted for a
low-angle viewing position.
Wrench set included.