Vortex Optics VIPER HS 4-16X44 LR RIFLESCOPE - Manual (Page 9)

HS LR
RIFLESCO PE
Once the CRS shims are installed, the elevation dial will stop turning
shortly past the original zero point when being returned (turning clockwise
direction) from a temporary elevation adjustment.
Turn the elevation knob a partial turn in a counter-clockwise direction
until the Radius Bar is correctly aligned with scope axis and zero marks
match. This setting will match the original zero point.
If re-zeroing at a future time, be sure to remove all CRS shims before
sight-in.
U SING THE CRS Z ERO S TOP
Correct alignment
for zero point.
Point at which the
knob stops turning.
M
AINTENANCE
The fully waterproof and fogproof Viper HS LR riflescope requires very
little routine maintenance other than periodically cleaning the exterior
lenses. The exterior of the scope may be cleaned by wiping with a soft, dry
cloth.
Cleaning
• Be sure to blow away any dust or grit on the lenses prior to wiping the
surfaces.
• Using your breath, or a very small amount of water or pure alcohol, can
help remove stubborn things like dried water spots.
All components of the Viper HS LR riflescopes are permanently lubricated,
so no additional lubricant should be applied.
Lubrication
When cleaning the lenses, be sure to use products, such as the Vortex Fog
Free cleaning products or LensPen, that are specifically designed for use on
coated optical lenses.
Note: Other than removing the turret caps, do not attempt to disassemble
any components of the riflescope. Disassembling of riflescope may void
warranty.
If possible, avoid exposing your Vortex riflescope to direct sunlight or any
very hot location for long periods of time.
Storage
17 16