Vortex Optics CROSSFIRE II 1X24 MUZZLELOADER SCOPE User Manual

Page 3

RIFLESCOPE

iflescope

djustments

Reticle Focus

This Crossfire II 1x Muzzleloader uses a fast focus eyepiece designed to
quickly and easily adjust the focus on the riflescope’s reticle.

To adjust the reticle focus:

• Look through the riflescope at a
blank white wall or up at the sky.

• Turn the eyepiece focus dial in or
out until the reticle image is as crisp as
possible.

• Note: Try to make this particular
adjustment quickly, as the eye will try to compensate for an out-of-focus
reticle.

Once this adjustment is complete, it will not be necessary to re-focus every
time you use the riflescope. However, because your eyesight may change
over time, you should re-check this adjustment periodically.

Warning

Looking directly at the sun through a riflescope, or any optical instrument,
can cause severe and permanent damage to your eyesight.

Windage and Elevation Adjustments

This Crossfire II riflescope incorporates adjustable elevation and windage
dials with audible clicks. Each audible click moves the bullet’s point-of-
impact 1/2 of a minute of angle (MOA).

1/2 MOA closely corresponds to 1/2 inch at 100 yards, 1/4 at 50 yards, and
1/8 inch at 25 yards. For example, it will take two (2) clicks of adjustment to
move the bullet’s point-of-impact approximately one inch at 100 yards.

How to adjust windage and elevation settings

Begin adjusting the windage and elevation settings by first removing the
outer covers. Then, move the turrets
in the direction you wish the bullet’s
point-of-impact to change. To make the
adjustments, rotate the adjustment dial
in the appropriate direction (up/down or
left/right) as indicated by the arrows.

After sight-in, you can re-align the
zero marks on the turret dials with the
reference dots if you wish (see Indexing
Adjustment Dials with Zero Reset on page
10). Replace outer covers when done.

To adjust settings, rotate dials.

Adjust the reticle focus