Vigo VG01025 - Manual (Page 3)

3
Adjustable wrench
Groove joint pliers
Plumber's putty
Pipe tape
Flat screwdriver
Your new faucet is designed for years of trouble-free performance.
Keep it looking new by cleaning it periodically with a soft cloth. Avoid abrasive
cleaners, steel wool and harsh chemicals as these will scratch, dull and/or damage
the finish and/or product and void your warranty.
Be sure to shut off water supply prior to installation.
Protect your eyes with safety glasses when cutting or soldering water
supply lines
Cover your drain to avoid losing parts.
Prior to beginning installation, turn off the cold and hot water lines and open the hot
and cold knobs on the old faucet to release build-up pressure.
When installing your new faucet, turn the connector nuts finger-tight, then use one
wrench to anchor the fitting and a second wrench to tighten the nut one additional
turn. Connections that are too tight will reduce the integrity of the system.
Wrap all threaded connections with Teflon tape available at your local hardware or
plumbing supply store. Always wrap in a clockwise direction.
All installations can vary depending on how your previous faucet was installed. Not
all necessary supplies to install your faucet are included, however, they are
available wherever plumbing supplies are sold.
Installation must be done by a qualified licensed plumber.
Prior to installation please read the instructions thoroughly, confirm that all
parts are included and visually inspect the unit for any defects.
If you have any questions please contact the Vigo Technical Support
Department before proceeding with installation.
2. CONNECT FLEXIBLE
HOSES TO THE BRASS
PIPES.
1. SHUT OFF WATER
SUPPLY. REMOVE OLD
FAUCET AND FLEXIBLE
HOSES. CLEAN SINK
SURFACE IN PREPARATION
FOR THE NEW FAUCET.
FLUSH WATER
CONNECTION AT HOME TO
MAKE SURE NO DEBRIS IS
STUCK IN THE LINE.
5
5. CONNECT FLEXIBLE
HOSES TO THE COLD AND
HOT WATER SUPPLY.
6. REMOVE ROD GUIDE NUT
AND ROD BALL RUBBER
GASKET. INSERT ROD BALL
ASSEMBLY INTO DRAIN BODY
AND THROUGH HOLE IN DRAIN
STOPPER. REPLACE ROD
GUIDE NUT WITH ROD BALL
RUBBER GASKET AND
TIGHTEN.
4. PLACE NEW FAUCET IN THE
POSITION ON THE SINK. FROM
UNDER THE SINK, PUT PLATE
AND GASKET AND THREAD NUT
ONTO THE PIN. TIGHTEN THE
NUT. PLACE SET SCREWS IN TO
THE NUT AND TIGHTEN THEM.
4
3
2
3. PLACE LOWER RING AND
O-RING TO THE FAUCET.
1
MAINTENANCE
TOOLS NEEDED
IMPORTANT POINTS
SAFETY TIPS
INSTALLATION
ASSEMBLY
PACKAGE CONTENTS
8. AFTER INSTALLATION IS COMPLETE TURN ON THE WATER SUPPLY
VALVES AND ALLOW BOTH HOT AND COLD WATER TO RUN AT LEAST
ONE MINUTE EACH. WHILE WATER IS RUNNING, CHECK FOR LEAKS,
ESPECIALLY AT HOOK-UPS TO SUPPLY LINES. TIGHTENING NUTS
SLIGHTLY WILL STOP ANY MINOR LEAKS.
7. INSERT POP-UP STEM
THROUGH HOLE ON FAUCET
BODY. CONNECT ROD BALL
ASSEMBLY TO LIFT ROD
USING SPRING CLIP TO
HOLD AND ADJUST. ATTACH
LIFT ROD WITH POP-UP
STEM BY INSERTING STEM
THROUGH HOLE IN LIFT
ROD. NOW ADJUST POP-UP
STEM TO CORRECT HEIGHT
AND HAND TIGHTEN LIFT
ROD SCREW.
6
7