Victorio VKP250 Food Strainer - Manual (Page 8)

Screen screw must be untwisted all the
way before you rotate the screen.
Assembly Instructions
(Use with parts diagram on p. 1)
View our assembly video on our website at www.Victorio.info.
2. Put the spring (10) onto the
shaft (9) that is already
installed in the strainer body.
3. Make sure the rubber gasket (12)
is seated on the inside rim of the
screen (14).
4. Place the small end of the
spiral (11) inside of the screen.
5. Push the spiral/screen assembly
onto the body (2).
6.
Line up the arrow on the
screen with the arrow on the
body. Twist the screen towards
the ‘ON’ direction until the
notches slide over the tabs on
the body. Then tighten the
screen screw (13) to keep the
screen in place.
1. To begin assembly, mount the Food Strainer body (2) to a table
or countertop. Do not over-tighten (see diagram on p. 2).
6