UVP B-100 Series - Manual (Page 3)

CAUTION
1. Wear hand and eye protection if filter glass is cracked.
Replace filter as soon as possible.
2. To avoid electrical shock hazard, unplug lamp
before servicing.
3. Bulb runs very hot; allow unit to fully cool before
servicing.
4. Bulb contains mercury. If bulb breaks, wear
gloves to remove. Dispose according to local
regulations.
5. B-100A, B-100A/R and B-100Y lamp housings become
hot during operation and care should be taken not to
touch them. Lamp handles do not heat even after
several hours of use.
The Lamp Funnel, for use with the Cool-Touch models,
can be used to direct the UV source directly where you want
it, eliminating stray UV radiation. To attach, remove the
plastic bezel from lamp by pulling side tabs apart and sliding
the bezel off the housing. Insert the retaining clips in the
four slots of the interior bezel as shown in Section A
Place the funnel in the lamp housing, reattach the bezel,
over funnel, by pulling tabs on the side of the lamp apart
and snapping into place.
PART NO. PART NAME (Where Used)
19-0126-01 LAMP FUNNEL (for B-100AP, YP models)
Accessories
2
3
Funnel
Lamp
Retaining
Clips
Section A
Tab
2
3
The Lamp Visor shields the user’s eyes from the UV
and directs the UV onto the object of analysis. The
Visor clips onto the sides of the lamp head. Side and
front facing views shown. Fig. 1 shows installation of
the Visor on the B-100A, B-100A/R and B-100Y
models.
Fig. 1
Side View
Front View
Clips
Fig. 2 Visor shown below is used with Cool-Touch
lamps. Visor clips onto the top of the lamp head.
Front and side facing views shown.
Fig. 2
Front View
Side view
Clip
Clips
PART NO. PART NAME (Where Used)
19-0124-01 LAMP VISOR (for B-100A, Y models)
19-0125-01 LAMP VISOR (for B-100AP, YP models)