Swiss+Tech Transformer Xi 12-In-1 User Manual

Page 2

This product is covered by a Limited Lifetime Warranty
to the original purchaser in that this product is free
from defects in workmanship and materials. During
the warranty period, this product will either be repaired
or replaced with a product of equal or greater value,
excluding any custom engraving or printing.

Damage through normal wear and tear (including
battery expiration and surface coatings), repair or
alteration, misuse, abuse, neglect, accident, improper
storage and handling, fire, negligence, improper
cleaning, circumstances not directly attributable to
manufacturing defects, or act of God is not included.

THIS WARRANTY IS IN LIEU OF ALL OTHER WARRAN-
TIES, EXPRESS OR IMPLIED, INCLUDING BUT NOT
LIMITED TO, IMPLIED WARRANTY OF MERCHANTA-
BILITY OR FITNESS FOR A PARTICULAR ISSUE.

This warranty gives you specific legal rights, and you may
also have other rights which vary from state to state.

Simply return your SWISS+TECH

brand product

postpaid and insured to: Swiss+Tech Products

701 Beta Drive, Unit 5
Cleveland, Ohio 44143

More information:

800.414.8799

www.swisstechtools.com

SWISS+TECH

Limited LIFETIME Warranty

Using the 11-in-1

Trransf

ansfor

ormer

mer™ 1

1--in

in--1

11-in-1 Battery Replacement

6 Swing-Out Screwdrivers:

#0, #1, #2 Flat & Phillips

Straight Edge

5 mm Marks

1/4 inch Marks

2. Remove old batteries.

3. Replace with two new CR1025 3V lithium
batteries or equivalent, taking care to place
the positive (+

+) or negative (–) side up as

indicated.

4. Replace the Switch Assembly by first
inserting the tabbed end into the slot.
Replace the screw turning clockwise with a
small Phillips screwdriver. Tighten gently.

DO NOT dispose of batteries in fire,
batteries may explode or leak.

1.. The batteries for the flashlight are under
the On/Off switch. Using a small Phillips
screwdriver, turn counterclockwise to remove
the screw. Gently lift the Switch Assembly
up and out to expose the Battery
Compartment.

Tabbed

End

(–)

Transformer™ 11-in-1 ships with the
FLASHLIGHT Switch in the Off Position.
Slide the switch TOWARD the Flashlight End
to turn it ON.

To use one of the SIX SCREWDRIVERS, press
with your thumb on the “TECH” end of the
SWISS+TECH

logo to push out the Middle

Screwdriver Compartment. Rotate the Middle
Screwdriver Compartment out 180 degrees
until it locks into place. This automatically
releases the Transformer™ 11-in-1 from the
Key Ring. Select one of the six screwdrivers
and rotate it out 180 degrees until it snaps
in place. To close, follow these instructions in
reverse. Be sure to hook the Key Ring while
closing the Middle Screwdriver Compartment.

Flashlight ON

Middle

Screwdriver

Compartment

Quick

Release

Key

Ring

Flashlight