Summit REX242W - Manual (Page 26)

26
Storage Drawer Removal (on some models)
Control Panel and Knobs
Pull the knobs straight off
the stem.
To remove the storage drawer:
1. Pull the drawer out all the way.
2. Tilt up the front and remove it.
To replace the storage drawer:
1. Insert glides at the back of the drawer
beyond the stop on range glides.
2. Lift the drawer if necessary to insert
easily.
3. Let the front of the drawer down, then
push in to close.
It is a good idea to wipe the control panel
after each use of the oven. Use a damp
cloth to clean or rinse. For cleaning, use
mild soap and water or a 50/50 solution of
vinegar and water. For rinsing, use clean
water. Polish dry with a soft cloth.
Do not use abrasive cleaners, strong liquid
cleaners, plastic scouring pads or oven
cleaners on the control panel; they will
damage the finish.
The control knobs may be removed for
easier cleaning.
Make sure the knobs are in the OFF posi-
tions and pull them straight off the stems
for cleaning.
The knobs can be cleaned in a dishwasher
or they may also be washed with soap
and water. Make sure the insides of the
knobs are dry before replacing.
Replace the knobs in the OFF position to
ensure proper placement.
Oven Shelves
Clean the oven shelves with an abrasive
cleanser or scouring pad. After cleaning,
rinse the shelves with clean water and dry
with a clean cloth.
NOTE: Take the shelves out of the oven be-
fore you begin the self-clean cycle or they
may discolor.
To make the shelves slide more easily, ap-
ply a small amount of vegetable oil or
cooking oil to a paper towel and wipe the
edges of the oven shelves with the paper
towel.
Wire cover holder
CAUTION: Before replacing your oven light bulb, turn the oven
light off and disconnect the electrical power to the range at
the main fuse or circuit breaker panel.
Care and cleaning of the range.
Oven Light Replacement (on some models)
Be sure to let the light cover and bulb cool
completely.
To remove the cover:
1. Hold a hand under the cover so it does
not fall when released. With fingers of
the same hand, firmly push back the
wire cover holder. Lift off the cover.
Do not remove any screws to remove
the cover.
2. Replace bulb with a 40-watt household
appliance bulb.
To replace the cover:
1. Place it into groove of the light recep-
tacle. Pull wire forward to the center of
the cover until it snaps into place.
2. Connect electrical power to the range.
Clean under the range
Safety Instructions
Operating Instructions
Care and Cleaning
Troubleshooting Tips
Consumer Support
Installation Instructions