Summit SINCCOM1 - Manual (Page 6)

Page 6 SUMMIT APPLIANCE
How to Use the Induction Cooktop
1. Center a suitable pot or pan on the cooktop and plug in
the appliance. The Power LED will start to flash.
2. Press the ON/OFF switch to turn on the unit. The
Power LED will be on steady.
The ON/OFF switch controls power to the appliance,
while the HEATING, TEMP and TIMER buttons control
the various functions. The digital Display shows
information about the functions.
3. When the Induction Cooktop is turned on, the HEATING
function will be displayed, and that LED will be lit. If you
want to use this function, press the ▼ and ▲ buttons to
adjust the HEATING rate to any of 7 levels (from 500W
to 1800W).
4. Press TEMP if you want to set the temperature. The
default temperature setting is 212°F (100°C), but this
can be adjusted by pressing ▼ or ▲. The temperature
range of the Induction Cooktop is 140°F to 464°F (60°C
to 240°C).
5. Press TIMER to set the cooking time. The TIMER LED
will be lit and the Display will flash the time. Adjust the
TIMER by pressing ▼ or ▲ (the range is from 0 to 170
minutes). When the TIMER button has not been pressed
for a few seconds, the Display will stop flashing and then
will automatically shift to either TEMP or HEATING. The
corresponding LED will be lit. To see the countdown
time on the Display, press TIMER again and the
remaining time will flash briefly.
WARNING: The appliance will be HOT during and after use.
6. The unit will automatically shut off after the set time has
elapsed.
NOTE: For frying in oil, used the TEMP function rather than
HEATING.
How to Use the Induction Cooktop