beautypg.com

Technical data, Installation instructions – Summit SWCD40 User Manual

Page 6

background image

- 6 -

Technical Data

Model Number

SWCD40

Type

2-drawer wine cellar

Capacity

40 bottles (5.3 ft

3

)

Electrical Rating

110V AC, 60 Hz

Rated Current

1.5A

Input Power

140W

Power Consumption

438 kWh/yr

Temperature Control Range

Upper Zone: 40-50°F

Lower Zone: 50-64°F

Net Weight

136.4 lbs

Unit Size (W×D×H)

23.4" x 22.4" x 33.1"

Installation Instructions

Your SWCD40 wine cellar may be installed either built-in or free-standing, but it is important that

the front of the unit be kept clear of obstructions, especially the vents at the bottom. If it is built in,

you should provide the following clearances to ensure the best operation and proper ventilation:

3/16” on both sides, 2” at the rear and 1/16” at the top. Don’t block airflow under the appliance.

Before using your wine cooler:
• Remove the exterior and interior packing.
• Never lift the unit by the drawer handles.
• Never install or operate the unit behind closed cabinet doors.
• Before connecting the appliance to the power source, let it stand upright for approximately 2

hours. This will reduce the possibility of a malfunction in the cooling system from handling

during transportation.

• Clean the interior surface with lukewarm water using a soft cloth.
• Place your appliance on a floor that is strong enough to support the appliance when it is fully

loaded.

• To level your appliance, adjust the front legs at the bottom of the appliance.
• Install the two stainless steel handles according to the following illustration: