Summit SCR1505 - Manual (Page 7)

UNIT REVIEW & INSPECTION
This refrigerator was completely inspected before leaving the factory. Check for signs of damage
when the unit is received. If there is any damage, contact your authorized distributor or manufacturer
immediately. Check that the following accessories are included with your refrigerator:
 4 wire shelves (packed in plastic wrap inside unit cabinet)
 16 shelf clips (packed separately in a plastic bag inside the cabinet)
INSTALLATION INSTRUCTIONS
This model is designed for interior use at a maximum operation temperature of 80.6°F (27°C) and 55%
humidity. It is meant to be free-standing and not built into an enclosure.
Do not place the unit near heat sources such as stoves, grills, radiators, etc. and do not place in areas
where direct sunlight may reach the unit.
CAUTION : This appliance is designed for storing and cooling beverages
and drinks. Do not store perishable food, medicine or other medical
products.
LOCATION
It is recommended that the rear portion and both sides of your refrigerator be at least 8 inches and 6
inches from the wall respectively, to allow air flow to the compressor and improve heat transfer.
Place your refrigerator on a level surface.
Minimum Distances
Once the unit is installed, check that it is level. If necessary, use the two front legs to adjust the height of
the unit.
7