Summit SWC530LBI-ST User Manual
Page 6
5
door.
3. Carefully lift off the door.
4. Unscrew the top hinge pin and cover and move to the opposite side.
5. Use the new bottom hinge provided in the plastic bag inside the wine cellar.
6. Place the door back onto the wine cellar, lining up the top hinge pin.
7. Connect the new bottom hinge pieces to the door and cabinet, using the
screws from the opposite side and following the same placement.
8. Keep the spare hinge, in case you ever want to set the door back to its original
position.
9. Install the handle on the right side of the door.
Installation of Handle
1. Remove the handle from inside the unit and unwrap it. There should be two
screws in the package.
2. Place the handle in position on the door frame so that the holes in the handle
are located over the matching holes in the door frame.
3. Gently pull back the rubber door gasket on the reverse side of the door frame
to expose the screw holes and insert a screw into each hole so that it engages
the handle.
4. Tighten each screw to secure the handle firmly.