Summit CM420ESBL - Manual (Page 8)

screw hole plugs
door pin
lower hinge bracket
screw hole plug
screw hole plugs
door pin
lower hinge bracket
screw hole plug
English
7
Reversing the Door
1. Remove the top hinge cover screw and then remove the top hinge cover. (see
fig. # 1)
2. Using a Phillips Head Screwdriver, loosen and remove the screws holding the
top hinge in place. (see fig. # 1)
3. Remove the top hinge and carefully lift off the door.
4. Remove the screw hole plug from the opposite side and insert the plug in the
screw hole openings of the just removed screws. (see fig. # 2)
5. Remove the door pin from the bracket of the lower hinge by turning counter
clockwise. Move the pin to the opposite hole and tighten. (see fig. # 3)
6. Loosen the screws holding the lower hinge bracket and remove the hinge.
(see fig. # 3)
7. Align the holes in the lower hinge bracket to the corresponding holes in the
opposite side of the cabinet. Insert and tighten the screws.(see fig. # 3)
8. Align the bottom hole on the left side of the door.
9. Align the pin of the top hinge with top hole on the left side of the door and
push into place. Replace the screws in the upper hinge bracket but do not
tighten all the way. (see fig. # 2)
10. Make sure the door closes easily but forms a tight seal. Adjust the door as
needed. Once you are satisfied with the door alignment, completely tighten
the upper door hinge screws.
11. Replace the hinge cover, insert the screw and tighten completely.
(see fig. # 2)
12. If the door does not close properly, refer to the section titled “Door
Alignment”.
fig.2
fig.3