Unbypass a point, Command 0 0 – Bosch D720 User Manual
Page 27
27
Unbypass a Point
I have this feature.
I do not have this feature.
This feature requires a passcode.
Unbypassing a point is a way to return a bypassed point to the security system so
it can respond to trouble and alarm conditions.
COMMAND
0 0
To Unbypass a Point:
1.
Ensure your security system is disarmed.
2.
Press the [COMMAND] bar. The Command mode indicator light
comes on.
3.
Press the [0] key, then press the [0] key again. The system is now the
Unbypass mode.
4.
To unbypass a point, press the number key that corresponds to the
number of the point that is flashing slowly, and then press the [ENT]
key. The point status light stops flashing, indicating the point is
unbypassed.