Schwank STSp-WP2 - Manual (Page 4)

Page 4 STSp-WP1/2 Supplement
RD: NOV, 2003
RL:2
KH
2. Assemble two reflector end plate
hangers by attaching 1 of the reflector
end plates to the hanger plate using the
supplied slotted screws and nuts. If the
system is longer than 10 feet, additional
reflector plate hangers must be assem-
bled. To assemble a reflector plate
hanger, attach 2 of the reflector end
plates to opposite sides of the hanger
plate and screws using the supplied slot-
ted screws and nuts. The reflector end
plate hangers are used on each end of the
total system. The reflector plate hanger
is used in between shades and allows the
reflector to be mechanically attached to
either side of the hanger. An alternative
method is to place only the hanger plates
on the tube and assemble the reflector
end plates after the system has been fully
or partially suspended. The reflector end
plates can be mounted to the hangers and
then install the shades or install the re-
flector end plates on both ends of the re-
flector and attaching the reflector to the
plate hangers. If this method is used, at-
tach the reflector near to the burner box
first and work down toward the vent
end.