Schwank ThermoControl Plus 4 - Manual (Page 20)

- 20 -
5.4 COPY
The COPY button offers the opportunity to copy all parameters of a certain circuit or the complete
time program and insert it into the program of one or many other control circuits.
5.5 To securely save or reload all parameters:
The setup technician can save all operational parameters to memory. If the parameters are
changed unintentionally, the old par ameters can easily be re-estab lished using the data saved in
memory. It is also possible to reload the factory default settings.
To Save
: Press CLR and +
simultaneously. The “SAVE”
symbol appears in the display.
Push DISP, the display will blink
while the parameters are saved.
Once saved the display
switches back to the main
menu.
To Load
: Press CLR and SEL simultaneously, the
“LOAd” symbol appears in the display. Press the
DISP
button and the parameters that were saved by the setup
technician, will reload. S witch from “LOAd” to
“FACt“,using the +/- button. If “FACt” appears in the
display push the DISP button to re-establish the factory
default parameters.
To copy parameters hold DISP (approx. 3 sec.,
chapter 5.2).
To copy time programs use the PR button (chapter.
4.4.1).
This example copies data from Zone 1 to Zone 2.
Push either the DISP (parameters) or PR (time
program) button
Zone 2 symbol start to blink. “COPY“ appears in the display
to indicate the copy mode. Push COPY to paste the Zone 1
data to Zone 2 (heating area 2).
The data of Zone 1 is now also located in Zone 2. The
Zone 2 symbol stops blinking to indicate the completion of
the copy process.
The data can continue to be copied to other Zones by
selecting Zone 3 to Zone 8 using the SEL button.
To finish copying the parameters press DISP button, or
press the PR button to finish copying time programs.