Robustel M1000 Quick Guide - Manual (Page 4)

Robustel GoRugged M1000 Quick Guide
RT_QG_M1000 _v.1.0.0
24.01.2014 4 / 6
Chapter 2. Hardware Installation
2.1 Insert/Remove SIM Card
SIM card is used for connecting to cellular network, you need buy SIM card from local operators.
Note:
1. Don’t forget to screw the cover for again-theft.
2. Don’t touch the metal surface of the SIM card in case information in the card is lost or destroyed.
3. Don’t bend or scratch your SIM card. Keep the card away from electricity and magnetism.
4. A SIM card set with PIN code cannot be used normally in the gateway without the correct PIN code.
5. Make sure to disconnect the power source from your modem before inserting and removing your SIM card.
2.2 Connect the External Antenna (SMA Type)
Connect this to an external antenna with SMA male connector. Make sure the antenna is for the correct frequency as
your GSM operator with impedance of 50ohm, and also connector is secured tightly.
2.3 Power On and Connect with PC
User can use the serial cable to connect the modem’s DB9 female connector to external controller / computer.