Robustel M1000 UP Quick Guide - Manual (Page 2)

Robustel GoRugged M1000 UP Quick Guide
RT_QG_M1000 UP_v.1.0.0
25.01.2014 2 / 7
1.4 Power Supply
The power supply range is
6 to 26 VDC .
Note: Please take care about the polarity, and do not make reverse connection.
Chapter 2. Hardware Installation
2.1 Insert/Remove SIM Card
SIM card is used for connecting to cellular network, you need buy SIM card from local operators.
Note:
1. Don’t touch the metal surface of the SIM card in case information in the card is lost or destroyed.
2. Don’t bend or scratch your SIM card. Keep the card away from electricity and magnetism.
3. A SIM card set with PIN code cannot be used normally in the gateway without the correct PIN code.
4. Make sure to disconnect the power source from your modem before inserting and removing your SIM card.

2.2 Connect the External Antenna (SMA Type)
Connect this to an external antenna with SMA male connector. Make sure the antenna is for the correct frequency as
your GSM/GPRS/UMTS/HSPA
operator with impedance of 50ohm, and also connector is screwed tightly.
Screw tightly
Negative Polarity Positive Polarity