BOXLIGHT CD-455m - Manual (Page 28)

20
U s i n g t h e P r o j e c t o r
Using the On-Screen Menus
The projector has six drop-down menus that allow you to make
image adjustments and change a variety of settings. Most of these
adjustments aren’t available directly from the keypad.
NOTE: Some menu items may be
grayed out (dimmed) at certain
times. This indicates the item is
not applicable to your setup (for
example, video standards do not
apply to computer sources) or the
item is not enabled until another
selection is made (for example,
Manual Tracking is not available
until Auto Image is turned off).
To open the on-screen menus, press the menu button on the
keypad or remote. This changes the volume, source, and standby
buttons on the keypad to menu navigation buttons. Press the
corresponding buttons to move the cursor up, down, left, or
right, or use the disk mouse on the remote. To select a menu,
move the cursor left or right to highlight the menu you want. The
drop-down menu appears.
F IGURE 13
Keypad navigation buttons and drop-down menu
To change a menu setting, use the up and down navigation but-
tons on the keypad or the disk mouse on the remote to move the
cursor up and down to the item you want to change (the selected
item is highlighted), then use the left and right mouse buttons to
adjust a setting. Some submenus, such as Brightness, consist of a
slider bar you use to increase or decrease a value; some sub-
menus, such as Standby Time, consist of options you scroll
through to select the desired one. All changes are saved when
you close the menus.
To access another menu, use the left and right navigation buttons
to move to the desired menu.
source
volume - volume +
standby
menu
use these four buttons to navigate
Display Audio Image Controls Language Status
> >
Brightness
Contrast
Tint
Color
Sharpness
Blank screen blue
Reset all
through the menus