Retsch PP 40 - Manual (Page 19)

08.02.2012 Retsch GmbH
19
0002
By turning and pressing the setting knob E all menu items can be selected and
parameters can be set.
Turning 1
By turning the different menu items can be selected.
Selected menu items are inversely represented.
Turning 2
Setting of parameters in opened menu items (please refer to Turning 1).
Pressing 1
Selected menu items are opened.
Pressing 2
Short pressing confirms the setting of the parameters.
Pressing 3
By constant pressing you return to the 1st menu level.
Setting possibilities via the display menu
For setting possibilities on the display described below please observe the menu structure on this page. The
selection bar in the display should be operated as follows:
Vertical manoeuvering through the structure by turning the setting knob
Horizontal manoeuvering through the menu structure by pressing the setting knob
Setting of numerical values or decisions by turning the setting knob
Confirmation of settings by pressing the setting knob
With “RETURN” you go to the previous menu structure level
By continuous pressing of the setting knob you return to the basic screen
Languages
Menu Display Languages
You can select the language here. After selection and pressing the setting knob the complete menu structure is
shown in this language.
False language selection
If the wrong language is accidentally selected switch off the unit at the main switch.
Keep the buttons pressed simultaneously and switch on the unit again.
After selecting the correct language switch off the equipment and then immediately on again.
Confirm your selection by pressing the setting knob.
The unit is now set permanently in your language and you are in the main menu.
Manual operation
If this function is set you can call and change all parameters and functions at any time.
This is also possible during milling.
Press programme
To get to the „Pressing programme“ function press the setting knob with “Manual
operation” set. Pressing programme 1 appears, flashing, in the display.
Furthermore data which may already have been stored in pressing programme 1
are also displayed.
By turning the setting knob to the right you can select other pressing programmes
2-32. Any parameters which may have been stored are displayed each time.
You can start the machine directly with the selected milling programme.
To return to „manual operation“ turn the setting knob completely to the left and
confirm with the setting knob.
Pressing time
00:00:01 to 99:59:59
Hours: Minutes: Seconds
The PP40 is started with the preselected pressing time.
A
b
b
.
5
Fig.11 Control Panel
Abb.16 Bedienfeld
E