Blue Rhino CPSV002704 - Manual (Page 6)

Page 4 Model# CPSV002704 Page 4 1.888.753.7137 Page 5
To complete assembly you will need:
• 1 precision-filled standard grill LP gas tank (20#)
with external valve threads
• 4 oz. leak check solution - mix 1 part dishwashing
soap with 3 parts water
1. Attach Post to Base
• Slide post into base
• Press down until snaps engage
2. Install Igniter Battery
• Open battery compartment by turning cap on
bottom of engine counter clockwise
• Place the supplied AA battery into compartment
– negative (-) end goes in first
• Secure cap by turning clockwise until it stops
3. Attach Engine to Post
• Place engine onto post
• Press down until the snaps engage
• Slide WaveTrap
™ into engine
• Position FineTune ™ ring and lure in place
• Place rain cover on engine and twist clockwise to
secure
4. Install LP gas tank
• Use only DOT approved 20# tanks with collar fully
intact
• Place full LP gas tank upright on cart so system is
arranged for vapor withdrawal
• Secure tank by attaching tank retention chain
• Connect gas line to tank by turning knob clockwise
until it stops
• Turn tank ON and test for leaks
• Spoon leak check solution at all “x” locations
• If any bubbles appear turn tank OFF, reconnect
and re-test
• If no bubbles appear after one minute turn tank
OFF, wipe away solution and proceed
• Place cover over tank
Quick & Easy Assembly
Tip: to locate a retailer in your neighborhood
that provides precision-filled tanks,
visit www.bluerhino.com or call toll free
1.800.258.7466.
X
X
X
X
X