Purenex Aquashower Filter - Manual (Page 3)

OPTION B
Install the Aquashower onto the shower kit holder and the shower kit hose.
Installing Filter Cartridge
1. Unscrew housing cap from housing body.
(Fig. 1)
2. Re-position two internal rubber o-rings if they
are dislodged. Place small o-ring into the groove
in the filter housing body. Place large o-ring into
groove in housing cap. Be sure the o-rings and
the grooves they are placed into are clean and
free of any grains of filtering media.
3. Place filter cartridge into housing body. Screw
the top and bottom parts together. (Fig. 2–4)
Hand tighten only. (External black body ring is
decorative only)
4. If this unit is equipped with a red plastic
thread protector or washer retainer at the inlet
of the housing body, remove and discard.
Now attach the filter by threading unit onto
the shower water pipe. Firm hand tightening
without plumber’s tape should be sufficient for
leak free operation. (Fig. 4–5) DO NOT OVER
TIGHTEN.
5. Allow the water to run through the filter for 30
to 60 seconds before the first use.
Aquashower
Shower Plumbing
Shower kit
Aquashower
Shower plumbing
Shower kit hose
Shower kit holder