Bifinett KH 700 - Manual (Page 4)

6 7
6 Assembling the
food processor
Fitting the mixing bowl
• Place the cover on the
motor block and turn
anti-clockwise until it is
seated tightly.
• Fit the mixing bowl.
Hold the bowl by the
handle and turn clock-
wise until it engages
with a “click”.
Fitting the lid
Note: Always ensure that the lid is properly
engaged before switching on the
device!
• Fit the lid on the mixing
bowl so that the reces-
ses of the lid match the
slots of the bowl.
• Turn the lid clockwise
until it engages with a
“click”. The marks on
the lid and the bowl
must match. The lug of
the lid now rests on the
handle of the bowl.
Fitting the filling shaft and pusher
Caution: Never use your fingers, spatula,
spoon handles or similar objects
for pushing foodstuff through the
filling shaft!
• You can add liquid and
solid food to the mixing
bowl through the filling
shaft. Use the pusher to
close-up the filling shaft
during operation to
avoid splashing or dust
from escaping (e.g.
when processing flour).
• Use the pusher to force
foodstuff through the fil-
ling shaft.
• The pusher is equipped
with a measuring cup. If
you remove it you can
reduce size of the filling
shaft. This can be useful
when cutting or grating
relative small food.
7 Working with the mixing bowl
The supplied accessories for the mixing bowl
consist of 6 grating and cutting discs, a
kneading blade and a chopping blade for ver-
satile use of the mixing bowl: Grating or cut-
ting, mixing or cutting, kneading or stirring.
7.1 Working with the cutting blade
Caution:
The cutting edges are very sharp! Exercise
special care when inserting and removing or
cleaning the cutting blade!
The bowl must first be properly locked in
position before inserting the cutting blade.
Risk of injury!
Never use your fingers, spatula, spoon han-
dles or similar objects for pushing foodstuff
through the filling shaft!
The cutting blade can be use to mix, chop or
kneading dough. For instance for chopping
meat, cheese, onions, herbs and nuts.
• Remove the cutting
blade from the pro-
tective case.
• Fit the mixing bowl to
the food processor.
• Fit the cutting blade on
the retainer and place
the latter on the drive
shaft.
• Add the ingredients to
the mixing bowl. Fit the
lid to the bowl and
insert the pusher in the
filling shaft. Switch on
the device by setting
the speed controller to the speed recom-
mended in the table. If you are uncertain
which speed should be used, use the fastest
speed (3).
Hints:
• Cut the ingredients in approximately 3 cm
large pieces before placing them in the
bowl.
• The device chops the ingredients very fast
so that you should only run it very briefly at
a time.
• Do not operate the device for longer than
30 seconds.
• Should ingredients be trapped in the bowl
or on the cutting blade:
- Switch off the device
- Remove the lid from the mixing bowl
- Remove the ingredients with a dough
scraper / spatula.
KH700_Kuechenmaschine_UK 24.11.2003 13:55 Uhr Seite 9