Powertrax 4120 - Manual (Page 13)

13
Figure 10
Install pinion shafts, block, pins and springs
Assembly of the LOCK-RIGHT Parts into the
Differential Case
Summary of steps in this section:
a) Install ring gear side coupler and washer
b) Install ring gear side driver and spacer
c) Install pinion shaft block and shafts
d) Install springs and pins
e) Install pins and springs another driver
f) Install other driver and spacer
g) Install other side gear and thrust washer
h) Install case cap
1. Place a thrust washer into the bottom of the case,
smoothest side up, and place the gear that formerly was in the
top of the case into the bottom (Figure 8).
2. Place a driver onto the side gear in the case, with
the teeth meashed, and place one of the spacers in the middle
(Figure 9).