Powertrax 9220883001 - Manual (Page 16)

14
33. Feel through pinion shaft open-
ing and verify both spacers and
drivers are fully seated onto cou-
plers. Verify all 8 saddle springs
are fully seated in holes.
32.
Keeping both drivers fully
engaged with couplers, rotate driv-
ers/couplers back 1/4 turn to
expose pinion shaft opening.
Saddle
springs
Pinion
shaft
opening
31. Check the gap between
drivers using check block. The
narrow side of the block should
fit between the drivers, but the
wider side should not fit.
Go No Go
If gap is incorrect, STOP and call
Powertrax Technical Support at
864-843-9275.
There may be a
problem with your differential case.